TW-EAV510 v6
LAN
• 4 x 10/100 Mb LAN ports
WAN
• 1 x 10/100/1000 Mb WAN port
VDSL2
• G.993.2 (VDSL2) protocol.
• PTM and ATM mode including dual latency
• Both Annex A and Annex B band plans
• Profiles supported: 8a/b/c/d, 12a/b, 17a
• US0
• Diagnostics mode/DELT
• Bitswaps, SRA and SOS/ROC
• FEXT Equalized UPBO
• Dying Gasp
• INM
• PhyR and G.INP (Framing Type 1)
• G.vector
• Virtual Noise
• Mac spoofing
ADSL protocols
• G.992.5 (ADSL2+), G.992.3 (ADSL2), G.992.2 (G.LITE), G.992.1 (G.DMT),
• ANSI T1.413
• ATM/PTM mode
• Annex A/L/M
• L2 power management
• Diagnostics mode/DELT
• Bitswaps and SRA
• INM
• PhyR and G.INP (Framing Type 1)
• Virtual Noise
• Mac spoofing
USB port
• 1 x USB 2.0 port
• LTE/4G/3G support (NAS/DLNA, printer server support option)
WLAN
• 300 Mbps Wlan
• 802.11g b/g/n
VPN
• PPTP, L2TP and GRE
Manual
Load balance feature and settings "Case study" on software release 14.10.2016
New fw release 04.11.2017
TW-EAV510_2.52.d12
(File in ZIP -format, unzip 1st before upgrade)
Official release is 2.52.d13
All changes after .d4 is made for LTE usage only
Release note 06.11.2017
a. Support half bridge feature
b. Support keep alive for xdsl
c. Support roaming command on 4G band auto mode
d. Add 3g/4g page on WAN service
e. Support band selection on LTE only
f. Modify system log on at+cops
g. Remove LANIPv6 hidden page when WAN IPv6 disable
h. Add big buffers for LTE dongles to speed
LTE data rate
i. Wifi defaults no AUTO channel, BAnd width 20 Mhz
j. Load balance feature add on 16.10.2016
k. DTIM value in Wifi - set to 75 (was 100)
l. Add IDS function into security setting - Limit hacker trial from WAN
m. Password field allow now only HEX-chracters
n. Change phy code to A2pvI042e.d26p. (Detailed xDSL code is attached by mail.)
o. Support http://192.168.0.254/tcwd.html to control watchdog.
p. LAN firewall on for http only.
q. Support wifi key =admin password
r. Fine tune of WIFI settings in noisy environment
s. Add more hacker protection to wifi and lan side firewall
t. New kernel L05, New Wifi AP , New xDSL driver, New Ethernet driver
u. Add support for TeleWel CAT 4 USB dongle
v. Add LTE and 3G band lock method for new TeleWell CAT 4 LTE dongle
x. Add LTE link reset if no WAN ip after LTE registered message from ISP
y. Add band lock method for TW-LTE CAT 4 module
z.Add extra domani check for keep alive function