TW-EAV510AC-LTE 5G router
2 internal 3 dBi 2.4GHz WLAN antennas and 2 internal 5GHz WLAN antennas (located on the back of the device, both frequencies on each antenna)
4 external 5G/LTE/4G/3G antennas (replaceable antennas, SMA connector)
4 x 10/100/1000 Mbps LAN ports
1 x 10/100/1000 Mbps LAN/WAN port
Please note that you can replace the antennas with outdoor 5G antennas to improve the data connection in rural areas. You will need four antennas or a combination antenna with multiple antennas in one unit. For example, this antenna model is well-suited for the purpose: 5G antenna with a fixed screw mount.
- Automatic ADSL2+ and VDSL2 modem
- 5G/4G: 700/800/1800/2600/3500, 3G: 900/2100
- 1600 Mbps WLAN 5 Ghz and 2.4 Ghz 802.11 b/g/n ac together
- 4 x 10/100/1000 MbpsLAN port
- Firewall
- Layer 3 Load balance
3G/4G/5G
- SIM normal size for LTE/4G/3G (Operator deal needed separately)
- Automatic Internet if APN=internet and PIN security disabled from SIM
- Max speed 600 Mbit/s / 200 Mbit/s
- Supported frequency:
5G and LTE
Sub-6G: n1,n2,n3,n5,n7,n8,n12,n20,n25,n28,n40,n41,n66,n71,n77,n78,n79
NSA and SA networks (sdx62)
LTE-FDD: B1/B2/B3/B4/B5/B7/B8/B12/B13/B14/B17/B18/B19/
B20/B25/B26/B28/B29/B30/B32/B66/B71
LTE-TDD: B34/B38/B39/B40/B41/B42/B48
WCDMA: B1/B2/B3/B4/B5/B8
Technical details for xDSL line
VDSL2
- G.993.2 (VDSL2) protocol
- PTM and ATM mode including dual latency
- Both Annex A and Annex B including dual latency
- Profiles supported: 8a/b/c/d, 12 a/b, 17a, 30a, 35b
- US0
- Diagnostics mode/DELT
- Bitswaps, SRA and SOS/ROC
- FEXT equalized UPBO
- Dying gasp
- INM
- G.INP
- G.vector
- Virtual Noise
ADSL protocols
- G.992.5 (ADSL2+), G.992.3 (ADSL2), G.992.2 (G-lite), G.992.1 (G.DMT)
- ANSI T1.413
- ATM/PTM mode
- Annex A/L/M
- L2 power management
- Diagnostics mode/DELT
- Bitswps and SRA
- INM
- PhyR and G.INP (framing type 1)
- Virtual noise
VPN
- PPTP, L2TP, OpenVPN, IPSec
Weight and size:
Weight: 568 g
DC power adapter : 131g 12 DC 1,6 A
Dimensions: 32 cm x 5 cm x 17,5 cm
Maximum hight with antennas: 21,5 cm
Speedtestings
FTP x 2 , Speedtest.net and Elisa VIihde simultanously
Bridge port to desired LAN port from WAN side ADSL, VDSL or EWAN
VPN -guide (pdf, english)
IPsec ,L2TP, PPTP, GRE
Management port change via ACL function ( WAN portti 80 --> 8080)
-After add just Apply
Freedom VPN install guide
OpenVPN support
Included start from fw versions 2.53.d6
OpenVPN -guide in english modemi-modem
tai Client - modem guide
OpenVPN bridge configurations ( fw.2.53.d6 or newer)
OpenVPN GRE new guide
Add more LTE module support
Mesh -wifi Instruction
Latest fw for all LTE and 5G links 17.07.2023 (release note sf/uk)
This fw will reset to factory defaults in upgrade
Major new feature 5G and 4G Bridge
List of previous info here
- Support PC behind PTM bridge can get IP and Internet surfing through EWAN.
- Fixed special character "Å" on DHCP table.
- Hide WiFi security on SNMP.
- Fixed EWAN no IP after reboot.
- Adjust WAN DNS behavior- Operator DNS is first priority. If no DNS on Operator will use 8.8.8.8.
- Fixed Samsung TV on Sony Areena APS issue.
- VLAN ID 7 tuki EWAN and PTM interface
- WiFi include now also WPA 3 support for security
- Add MEsh Wi-FI support
- Add SNR setting for DSL network (default -1 = auto)
- Supported SMS control function.
- Supported all bands selection for EM12/EM20
- Add GRE tap 8 tunnel support
- List of all supported LTE modules
- Improve LED all off on hidden page-http://192.168.0.254/ledtest.asp
- Support M50U dual SIM. (SIM1 first after boot. SIM1 fail, use SIM2.Will NOT support SIM1 and SIM2 failover and fallback feature.)
- Support Band info when only one band in EP-06 CA usage.
- Support NAT loopback to internal FTP server (port =21)
- Fixed 4TB UI display issue.
- Fixed Huawei MA5616 DSLAM 17a sync issue in short loops27. Support EP-06E all band.
- Quactel em12 lte cat 12 support ,max 600 Mbps and Quectel EM20 1200 Mbps CAT 20 support
- Fixed port forwarding-pptp application.
- Fixed LTE BW value display in UI
- Supported TLS=1.2 for HTTPs.
- Fixed Speedtest traffic issue when disable/enable LTE interface on EWAN/LTE all up.
- Support Mail alert
- Change this command setting-echo 'net.core.netdev_max_backlog = 5000'
- Change customization- disable G.Vector.
- Fail over in multiple WAN link use - fix
- Add fixed ip settings for 40 entry DHCP server
- Add fix for memory leak with 3/4/5G modules
- Support EP-06 band selection.
- Support EM-12 band selection.
- MNC/MCC translation on 8202G info.
- Remove AT+CUSBCFG in code.
- Support 8202G LTE CA info.
- Realtek wifi security SDK päivitys
- Adds more band info to 3/4/5G UI
- Fixed security 1st key =0 cause security to default after power off/on.
- Fixed IPv6 enabled get slow issue.
- Fixed IPv6 enabled get slow issue.
- Fixed EM12 no traffice issue. (No gateway IP issue.)
- Change auto upgrade path to telewell.fi. from www.telewell.fi
- Change parameters as below speedup trafic:
- echo "4194304" > /proc/sys/net/netfilter/nf_conntrack_max
- echo "524288" > /sys/module/nf_conntrack/parameters/hashsize
- On auto upgrade feature. The Router will back to default if there is a change in config.
- Add more 5G NSA channel info
Latest fw 17.07.2023
Manual TW-EAV510AC-LTE+5G
5G module update via router
List of latest info from this link
- Support PC behind PTM bridge can get IP and Internet surfing through EWAN.
- Fixed special character "Å" on DHCP table.
- Hide WiFi security on SNMP.
- Fixed EWAN no IP after reboot.
- Adjust WAN DNS behavior- Operator DNS is first priority. If no DNS on Operator will use 8.8.8.8.
- Fixed Samsung TV on Sony Areena APS issue.
- add Samba HD / NAS support up to 4TB USB 3.0 hd (Linux hd format support;FAT16、FAT32、NTFS Ext2、Ext3、Ext4
- Hard disk must be preformatted to one above formats
- Best are native Linux Ext4 and Windows NTFS
- Add more support for LTE module
- -TeleWell LTE CAT 6 and 4 model , Sierra EM7565, Telit LM940 Huawei E3272, Huawei E3276h-150
- VLAN ID 7 tuki EWAN and PTM interface
- WiFi include now also WPA 3 support for security
- Add MEsh Wi-FI support
- Add SNR setting for DSL network (default -1 = auto)
- Supported SMS control function.
- Supported all bands selection for EM12/EM20
- Add GRE tap 8 tunnel support
- List of all supported LTE modules
- Improve LED all off on hidden page-http://192.168.0.254/ledtest.asp
- Support M50U dual SIM. (SIM1 first after boot. SIM1 fail, use SIM2.Will NOT support SIM1 and SIM2 failover and fallback feature.)
- Support Band info when only one band in EP-06 CA usage.
- Support NAT loopback to internal FTP server (port =21)
- Fixed 4TB UI display issue.
- Fixed Huawei MA5616 DSLAM 17a sync issue in short loops27. Support EP-06E all band.
- Quactel em12 lte cat 12 support ,max 600 Mbps and Quectel EM20 1200 Mbps CAT 20 support
- Add support for new M50 USB 3.0 adapter for LTE modules
- APN behaviour TeleWell M50 USB 3.0 adapter Em12 LTE CAT module
- Fixed port forwarding-pptp application.
- Fixed LTE BW value display in UI
- Supported TLS=1.2 for HTTPs.
- Fixed Speedtest traffic issue when disable/enable LTE interface on EWAN/LTE all up.
- Support Mail alert
- Change this command setting-echo 'net.core.netdev_max_backlog = 5000'
- Change customization- disable G.Vector.
- Fail over in multiple WAN link use - fix
- Enhance USB 3.0 and LTE module CAT 6,12,20 support
- Enhance Multiple DNS usage
- USB port speed enhanced for 4G / 5G and usb port start delayed for 3/4/5G module period
- Add fixed ip settings for 40 entry DHCP server
- Add fix for memory leak with 3/4/5G modules
- Support EP-06 band selection.
- Support EM-12 band selection.
- MNC/MCC translation on 8202G info.
- Remove AT+CUSBCFG in code.
- Support 8202G LTE CA info.
- Realtek wifi security SDK päivitys
- Adds more band info to 3/4/5G UI
- Fixed security 1st key =0 cause security to default after power off/on.
- Fixed IPv6 enabled get slow issue.
- Fixed IPv6 enabled get slow issue.
- Fixed EM12 no traffice issue. (No gateway IP issue.)
- Change auto upgrade path to telewell.fi. from www.telewell.fi
- Change parameters as below speedup trafic:
- echo "4194304" > /proc/sys/net/netfilter/nf_conntrack_max
- echo "524288" > /sys/module/nf_conntrack/parameters/hashsize
- On auto upgrade feature. The Router will back to default if there is a change in config
- Enhanced Dualstack support on 5G SDX 62
- Fixed EWAN port speed in 1Gb link to Fiber ethernet network