TW-EAV510AC 4G, ADSL, VDSL, WAN,5x1Gb swicth, firewall

ADSL2+ and VDSL2 modem which can be used to creat easily Local Area Network.Automatic ADSL2+ and VDSL2 modem, 5 x 1 Gb Ethernet, 1 x USB 2.0 port for DLNA and LTE/4G/3G use, Wlan access point 1200 Mbps 5 Ghz and 2,5 Ghz, Firewall

EAN
64300109233xxx

Automatic ADSL2+ and VDSL2 modem, 1200 Mbps WLAN 5 Ghz and 2.4 Ghz, 5 x 1 Gb ethernet port, Firewall, USB 2.0 port for DLNA and 3G/4G use

  • Installation: Desk or wall
  • Realtek dualcore CPU P8685P (600Mhz)
  • Linux kernel 3.18  with with all updates (8)
  • 2 x 3 dBi Wifi Antenna
  • Firewall as default
  • 5 x 1000 Mb ethernet (4 x LAN, 1 x WAN)
  • Technical details for xDSL line

VDSL2

- G.993.2 (VDSL2) protocol

- PTM and ATM mode including dual latency

- Both Annex A and Annex B including dual latency

- Profiles supported: 8a/b/c/d, 12 a/b, 17a and 30a 

- US0

- Diagnostics mode/DELT

- Bitswaps, SRA and SOS/ROC

- FEXT equalized UPBO

- Dying gasp

- G.INP

- G.vector

- Virtual Noise

 

ADSL protocols

- G.992.5 (ADSL2+), G.992.3 (ADSL2), G.992.2 (G-lite), G.992.1 (G.DMT)

- ANSI T1.413

- ATM/PTM mode

- Annex A/L/M

- L2 power management

- Diagnostics mode/DELT

- Bitswps and SRA

- INP / G.INP

How to upgarde  (or use upgarde(auto) function from user interface inside router os)

-Check that INET LED is OK
-Press reset button 2 sec and release-->  All led  comes up --> Wait until INET LED is on again
All user settings are kept as they where set to router

After upgarde is recommend -->
Proceed Factory defaults, Press reset over 5 sec, modem boot with new factory defaults

Information of all updates and fixes 

26.08.2019

Firmware 1.1.00.62 (27Mb)

add: Quectel EP06 CAT 6 support,
Huawei E392, E398 and E3276 support
Load balance between active Internet -WAN link
ADSL/VDSL, LTE, EWAN
1.1.00.37 version has Multicast priority for VDSL 2 speeds
-add more  infor for 4G networks when used with Quectel EP06
-add huawei E3276  support

After fw upgarde please proceed reset to factory defaults procedure.
Then all funtions are correct.
Press reset-microswicth 10 seconds  when INT-LED is on and release it.
Modem will reboot and goes to correct factory defaults.


26.08.2019
Fw for local updates 1.1.00-62

Full history of release notes