TW-EAV510AC-LTE 5G, 3G/4G,5G SDX62, xDSL modem, Wifi AC, router, firewall, assembled in finland

EAN
6430010927143

- Automatic ADSL2+ and VDSL2 modem

- 5G/4G: 700/800/1800/2600/3500, 3G: 900/2100

- 1600 Mbps WLAN 5 Ghz and 2.4 Ghz 802.11 b/g/n ac  together

- 4 x 10/100/1000 MbpsLAN port

- Firewall

- Layer 3 Load balance

 

 

3G/4G/5G

- SIM normal size for LTE/4G/3G (Operator deal needed separately)

- Automatic Internet if APN=internet and PIN security disabled from SIM
- Max speed 600 Mbit/s / 200 Mbit/s

- Supported frequency:  


5G and LTE

Sub-6G: n1,n2,n3,n5,n7,n8,n12,n20,n25,n28,n40,n41,n66,n71,n77,n78,n79

NSA and SA networks (sdx62)

LTE-FDD: B1/B2/B3/B4/B5/B7/B8/B12/B13/B14/B17/B18/B19/
B20/B25/B26/B28/B29/B30/B32/B66/B71
LTE-TDD: B34/B38/B39/B40/B41/B42/B48
WCDMA: B1/B2/B3/B4/B5/B8




Technical details for xDSL line

 

VDSL2

- G.993.2 (VDSL2) protocol

- PTM and ATM mode including dual latency

- Both Annex A and Annex B including dual latency

- Profiles supported: 8a/b/c/d, 12 a/b, 17a, 30a, 35b

- US0

- Diagnostics mode/DELT

- Bitswaps, SRA and SOS/ROC

- FEXT equalized UPBO

- Dying gasp

- INM

- G.INP

- G.vector

- Virtual Noise

 

ADSL protocols

- G.992.5 (ADSL2+), G.992.3 (ADSL2), G.992.2 (G-lite), G.992.1 (G.DMT)

- ANSI T1.413

- ATM/PTM mode

- Annex A/L/M

- L2 power management

- Diagnostics mode/DELT

- Bitswps and SRA

- INM

- PhyR and G.INP (framing type 1)

- Virtual noise

 

 

VPN

- PPTP, L2TP, OpenVPN, IPSec
 

 

Wight and size:
 

Gift box 1082 g

Router  568 g

DC power adapter : 131g  12 DC 1,6 A
 

Width :   32cm

thicknes : 5cm

dimension: 17,5 cm

Maximum hight  when all antenna are installed: 21,5cm

Speedtestings 
 FTP x 2 , Speedtest.net and Elisa VIihde simultanously

 

Bridge port to desired   LAN port from WAN side ADSL, VDSL or EWAN
 

VPN -guide (pdf, english)
IPsec ,L2TP, PPTP, GRE 


Management port change via ACL function ( WAN portti 80 --> 8080)

-After add just Apply


 

Freedom VPN install guide


OpenVPN support  
Included start from fw versions 2.53.d6

OpenVPN -guide in english modemi-modem
tai Client - modem guide
 

OpenVPN  bridge configurations ( fw.2.53.d6 or newer)

OpenVPN GRE  new  guide

Add more  LTE  module support

Mesh -wifi Instruction

Latest fw for all LTE and 5G links 07.10.2022 (release note sf/uk)

This fw  will reset to factory defaults in upgrade
Major new  feature  5G and 4G Bridge

 


 List of previous info here

  1.  Support PC behind PTM bridge can get IP and Internet surfing through EWAN.
  2.  Fixed special character "Å" on DHCP table.
  3.  Hide WiFi security on SNMP.
  4.  Fixed EWAN no IP after reboot.
  5.  Adjust WAN DNS behavior- Operator DNS is first priority. If no DNS on Operator will use 8.8.8.8.
  6.  Fixed Samsung TV on Sony Areena APS issue.
  7.  VLAN ID 7 tuki EWAN and PTM interface
  8.  WiFi  include now  also WPA 3  support for security
  9.  Add MEsh Wi-FI support
  10.  Add SNR  setting for DSL network (default -1 = auto)
  11.  Supported SMS control function.
  12.  Supported all bands selection for EM12/EM20
  13.  Add GRE tap 8 tunnel support
  14.  List of all supported LTE modules
  15.  Improve LED all off on hidden page-http://192.168.0.254/ledtest.asp
  16.  Support M50U dual SIM. (SIM1 first after boot. SIM1 fail, use SIM2.Will NOT support SIM1 and     SIM2 failover and fallback feature.)
  17.  Support Band info when only one band in EP-06 CA usage.
  18.  Support NAT loopback to internal FTP server (port =21)
  19.  Fixed 4TB UI display issue.
  20.  Fixed Huawei MA5616 DSLAM 17a sync issue in short loops27. Support EP-06E all band.
  21.  Quactel em12 lte cat 12 support ,max 600 Mbps and Quectel EM20 1200 Mbps CAT 20 support
  22.  Fixed port forwarding-pptp application.
  23.  Fixed LTE BW value display in UI
  24.  Supported TLS=1.2 for HTTPs.
  25.  Fixed Speedtest traffic issue when disable/enable LTE interface on EWAN/LTE all up.
  26.  Support Mail alert
  27.  Change this command setting-echo 'net.core.netdev_max_backlog = 5000'
  28.  Change customization- disable G.Vector.
  29.  Fail over in multiple WAN link use - fix
  30. Add  fixed ip settings for 40 entry DHCP server  
  31. Add fix for  memory leak with 3/4/5G modules
  32. Support EP-06 band selection.
  33. Support EM-12 band selection.
  34. MNC/MCC translation on 8202G info.
  35. Remove AT+CUSBCFG in code.
  36. Support 8202G LTE CA info.
  37. Realtek wifi security SDK päivitys
  38. Adds more band info to 3/4/5G UI 
  39. Fixed security 1st key =0 cause security to default after power off/on.
  40. Fixed IPv6 enabled get slow issue.
  41. Fixed IPv6 enabled get slow issue.
  42. Fixed EM12 no traffice issue. (No gateway IP issue.)
  43. Change auto upgrade path to telewell.fi. from www.telewell.fi
  44. Change parameters as below speedup trafic:
  45. echo "4194304" > /proc/sys/net/netfilter/nf_conntrack_max
  46. echo "524288" > /sys/module/nf_conntrack/parameters/hashsize
  47. On auto upgrade feature. The Router will back to default if there is a change in config.
  48. Add more 5G NSA channel info
     


 

Latest fw 07.10.2022


Manual TW-EAV510AC-LTE+5G

5G module update via router 
 


 List of latest info from this link

  1.  Support PC behind PTM bridge can get IP and Internet surfing through EWAN.
  2.  Fixed special character "Å" on DHCP table.
  3.  Hide WiFi security on SNMP.
  4.  Fixed EWAN no IP after reboot.
  5.  Adjust WAN DNS behavior- Operator DNS is first priority. If no DNS on Operator will use 8.8.8.8.
  6.  Fixed Samsung TV on Sony Areena APS issue.
  7.  add  Samba  HD / NAS support  up to 4TB USB 3.0 hd (Linux hd format support;FAT16、FAT32、NTFS Ext2、Ext3、Ext4
  8.  Hard disk must be preformatted to one above formats
  9.  Best are native Linux  Ext4  and Windows NTFS
  10.  
  11.  Add more support for LTE module
  12.  -TeleWell LTE CAT 6 and 4 model , Sierra EM7565, Telit LM940 Huawei E3272, Huawei E3276h-150
  13. VLAN ID 7 tuki EWAN and PTM interface
  14.  WiFi  include now  also WPA 3  support for security
  15.  Add MEsh Wi-FI support
  16.  Add SNR  setting for DSL network (default -1 = auto)
  17.  Supported SMS control function.
  18.  Supported all bands selection for EM12/EM20
  19.  Add GRE tap 8 tunnel support
  20.  List of all supported LTE modules
  21.  Improve LED all off on hidden page-http://192.168.0.254/ledtest.asp
  22.  Support M50U dual SIM. (SIM1 first after boot. SIM1 fail, use SIM2.Will NOT support SIM1 and     SIM2 failover and fallback feature.)
  23.  Support Band info when only one band in EP-06 CA usage.
  24.  Support NAT loopback to internal FTP server (port =21)
  25.  Fixed 4TB UI display issue.
  26.  Fixed Huawei MA5616 DSLAM 17a sync issue in short loops27. Support EP-06E all band.
  27.  Quactel em12 lte cat 12 support ,max 600 Mbps and Quectel EM20 1200 Mbps CAT 20 support
  28.  Add support for new  M50 USB 3.0 adapter for LTE modules
  29.  APN behaviour TeleWell M50 USB 3.0 adapter Em12  LTE CAT module
  30.  Fixed port forwarding-pptp application.
  31.  Fixed LTE BW value display in UI
  32.  Supported TLS=1.2 for HTTPs.
  33.  Fixed Speedtest traffic issue when disable/enable LTE interface on EWAN/LTE all up.
  34.  Support Mail alert
  35.  Change this command setting-echo 'net.core.netdev_max_backlog = 5000'
  36.  Change customization- disable G.Vector.
  37.  Fail over in multiple WAN link use - fix
  38.  Enhance  USB 3.0  and  LTE module CAT 6,12,20 support
  39.  Enhance Multiple DNS usage
  40. USB port speed enhanced  for 4G / 5G and usb port start delayed for 3/4/5G module period
  41. Add  fixed ip settings for 40 entry DHCP server  
  42. Add fix for  memory leak with 3/4/5G modules
  43. Support EP-06 band selection.
  44. Support EM-12 band selection.
  45. MNC/MCC translation on 8202G info.
  46. Remove AT+CUSBCFG in code.
  47. Support 8202G LTE CA info.
  48. Realtek wifi security SDK päivitys
  49. Adds more band info to 3/4/5G UI 
  50. Fixed security 1st key =0 cause security to default after power off/on.
  51. Fixed IPv6 enabled get slow issue.
  52. Fixed IPv6 enabled get slow issue.
  53. Fixed EM12 no traffice issue. (No gateway IP issue.)
  54. Change auto upgrade path to telewell.fi. from www.telewell.fi
  55. Change parameters as below speedup trafic:
  56. echo "4194304" > /proc/sys/net/netfilter/nf_conntrack_max
  57. echo "524288" > /sys/module/nf_conntrack/parameters/hashsize
  58. On auto upgrade feature. The Router will back to default if there is a change in config
  59. Enhanced  Dualstack support on 5G SDX 62